Cog Coaster Marble Run Model Kit
Cog Coaster Marble Run Model Kit
Cog Coaster Marble Run Model Kit
Cog Coaster Marble Run Model Kit

Cog Coaster Marble Run Model Kit

Regular price
$49.90
Sale price
$49.90
Shipping calculated at checkout.

 Is it a roller coaster? A marble waterfall? Whatever you call it, it's a blast to build and just as much fun to operate. When we're at a show, we find we have to "test" our display model every time we walk by.

Turn the crank and the marbles are carried to the top of a ramp by a giant gear. From there, a series of steps moves them even further up, until they are deposited at the top of a series of ramps, there to drop back down and do it all over again.

Finished model is 10" wide x 9" deep x 8" high. Kit comes with 236 laser-cut plywood pieces, steel marbles, bushings, axles, glue, and all other parts needed for assembly. Recommended for ages 14 & up.

Notes from Alex:

While the Tower Coaster was the model we chose for a display, these comments would apply to all four coasters.

This is one of my personal favorites out of all the wood kits we sell. While it has  challenging moments, assembly is fairly straightforward. Build time is 7-8 hours, but that would not include the time needed to make sure that any glued sub-assemblies are dry. This is definitely not something that can be done in an evening.

The side rails are attached to the ramps using dowels, which must be pushed into place and then cut flush. The instructions show a utility knife being used for this, but flush-cutting wire cutters works as well - you just need to clean up the little stub. An X-acto saw works best, but most people don't have one laying around.

We recommend putting silicone or rubber feet on the bottom of the model to keep it from sliding while in operation.